What are the precautions when using column lift- Ningbo Alpha Automation Co., Ltd.

Before using the Column Lift, it is essential to conduct a thorough and detailed inspection. This process not only includes an inspection of the appearance of the column to ensure that it is not damaged or deformed, but also a comprehensive evaluation of the hydraulic oil, air pressure and electrical systems to ensure that there are no leaks or abnormal sounds. At the same time, the sensitivity and reliability of the control system must also be verified to ensure that it can accurately execute the operating instructions. These inspection steps are the basis for the safe and stable operation of the column. Any minor faults or abnormalities may pose a serious threat to operational safety.

When placing a vehicle or a heavy object on the column, it is extremely important to ensure that the center of gravity is aligned with the support point of the column. The deviation of the center of gravity may cause the column to tilt or shake during the lifting process, causing safety accidents. Therefore, before placing a vehicle or a heavy object, its size and weight must be carefully measured and reasonably distributed according to the load-bearing capacity and size limit of the column. During the lifting process, the operator should pay close attention to the status of the vehicle or heavy object to ensure that it is stable and without abnormal sounds.

When operating the column, the corresponding operating procedures must be strictly followed. This includes the correct start and stop procedures, control of lifting speed, and the use of emergency stop buttons. Before starting the lifting column, make sure that no one is around to prevent accidental injuries. During the lifting process, the operation should be slow and smooth, and sudden acceleration or deceleration should be avoided to avoid damage to the lifting column or the vehicle. In addition, in an emergency, the operator should be able to quickly press the emergency stop button to cut off the power and immediately stop the operation of the lifting column.

The maintenance and care of the lifting column should also not be ignored. It is necessary to regularly check the hydraulic oil, air pressure and electrical systems to ensure that they are in good working condition. The hydraulic oil system should regularly replace the hydraulic oil and clean the oil tank and filter; the air pressure system needs to check the connection of the air pressure gauge and the air pipeline to ensure that the air pressure is stable and the pipeline is unobstructed; the electrical system should check the connection of the wires and connectors to ensure that the electrical components are working properly. At the same time, regularly clean the external surface of the lifting column to remove oil and dust to maintain its good appearance and performance.

When using lifting columns, you should also pay attention to the following key points: first, avoid overloading to prevent damage to the lifting column due to excessive load; second, avoid using the lifting column in harsh environmental conditions, such as high temperature, humidity or corrosive environment, these factors may significantly affect the performance of the lifting column; third, avoid using the lifting column continuously for a long time to prevent the equipment from overheating or increased wear; finally, never perform reverse operation when the lifting column has not completely stopped, so as to avoid damage to the equipment or cause a safety accident.